Table of Contents
Advertisement
CHAPTER 2 INSTALLATION
INSTALLATION PROCEDURE FOR ISDN-PRI
Cable Connection via CONN Card
When you use a coaxial cable, connect the cable to a NT1 equipment via the CONN (PZ-M542/PZ-M557)
card as shown below.
The figure in next page shows an example of the cable connection when the DTI/PRT card is mounted on
the AP05 slot of PIM0.
Cable Connection via the CONN Card
PBX
BWB
NT1
DTI/PRT
COAXIAL CABLE
CONN
LTC0/LTC1/LTC2/LTC3 CONNECTOR
MAXIMUM 6 dB loss at 1024 kHz
– 61 –
NWA-008852-001 Rev.5.0
98ch2001.fm
Advertisement
Table of Contents
