System Programming; System Commands - Bosch Solution 64 Installer's Manual


This section contains the different parameters required that are
system related features.
The commands menu will allow you to view the panel status,
system troubles, history log, factory default and entering
service mode.
Some of the key parameters in these menus are the setting of
the date/time under Clock and Schedules which control all the
automated time functions of the system.
S ys t e m c o mma n d s
System > Commands >
Panel Status
This command displays the following panel related information
on the keypad display.
Line 1 Displays:
The panel number that you are getting information from (eg.
Node 1 = Panel 1 etc). The Solution 64 is only configured to
work with one panel.
Line 2 Displays:
The panel name and firmware version number.
Line 3 Displays:
The current panel temperature, panel power supply voltage
and any system troubles which are in effect. This line scrolls all
events continiously
Press [MENU] + [7] + [0] + [0] to view the panel status.
1)
Panel 001 P001
Solution 64 Ver RC3 1.01
Temperature 28˚C
Press OK or MENU
3) Press [OK] to exit when finished.
System > Commands >
System Trouble
This command lists any system troubles which are currently
in effect on the system. Information is diplayed in a list format
allowing you to select a paticular event and then drill down to
view more specific information.
System trouble events such as Failure To Comminicate or Telco
Line Fail are grouped under System Trouble in the list while
Bosch Security Systems | 11/05 | BLCC110I
System Programming
- -
MENU 7-0-0
  
- -
MENU 7-0-1
  
open zones are displayed individually one per line.
When the keypad is in standby mode, system troubles and
open zones will be displayed on the status line of the keypad.
From this mode you can access the list of troubles by pressing
the down arrow.
1) Press [MENU] + [7] + [0] + [1] and use the up and down arrows
to highlight the trouble event in the list then press [OK].
P001 System Trouble
Z001 Zone 1 Name
Z002 Zone 2 Name
Press  OK or MENU
2) Selecting System Trouble from the list will show the specific
panel version information to be displayed in the first two lines
while the third line of the display will scroll all current system
trouble events.
Panel 001 P001
Solution 64 Ver 1.02
Date and Time
Press OK or MENU
3) Selecting a Zone from the list will show the currrent zone state.
Zone 1 name Z001
EOL=Open
Press OK or MENU
If no System Troubles are in effect the keypad will display.
4)
There are no
System troubles
Press OK or MENU
5) Press [OK] or [MENU] when finished.
i
When in stand-by mode keypads will display system trouble
events on the third line of the display.
Note
S e c t ion 1 1
11-1