Installing The Router Module To The Ach550 Drive With The E-Clipse Bypass Option (Us Only) - ABB ACH550 Installation Manual

Installing the router module to the ACH550 drive with the E-Clipse
Bypass option (US only)
This section describes how to install the router module to the drive
when the E-Clipse Bypass option is used.
The ACH550 drive with the E-Clipse Bypass option (US only) is an
ACH550 AC-adjustable-frequency drive in an integrated package
with a bypass motor starter. For more information, see E-Clipse
Bypass Configurations for ACH550 Drives User's Manual
(3AUA0000016461 [English]).
WARNING! Before installation, switch off the drive power supply.
Wait at least five minutes to ensure that the capacitor bank of the
drive is discharged. Switch off all dangerous voltages connected
from external control circuits to the inputs and outputs of the drive.
Note: Do not connect the router module to the network before you
have commissioned the device!
1. Before installation, switch off the drive power supply for at least
5 minutes to discharge the capacitor bank of the drive. For
more information, refer to
2. Remove the plug connected to the X1 terminal of the drive.
Safety instructions
Installation of the module
21
on page 5.