Table 6-29: G1180 / G2180 Service Mode (Continued On Table 6-30) - Miele G1000 Technical Information

G1000 / G2000 Dishwashers
Flashing rhythm
of Intake/Drain Function
LED
Pos. 0:
Long Short
Software
version
- -
ID check
Pos. 1:
Fault
memory
display
and
deletion
- 1
Pos.2:
- 2 Compon
ent test

Table 6-29: G1180 / G2180 Service Mode (Continued on Table 6-30)

Programming
Do not press the
Program button. The
Intake/Drain LED is off.
Press the Program
button 1x.
If the fault is indicated in
the SaniWash LED,
check if additional faults
are registered. Press the
Program button and hold
it until the Intake/Drain
LED flashes. Then press
the Program button
briefly. *1
To delete the fault
memory, press the
Program button and hold
until the Intake/Drain
LED flashes. Then press
the Program button until
the SaniWash LED goes
out.
Press the Program
button 2x.
To start the component
test, press the Program
button and hold until the
Intake/Drain LED
flashes. Then press the
Program button briefly.
Press the Program
button again to access
each of the following
components. *1
147
Indication
The Sani-Wash LED is off or
flashes. Shows the software
version ID No., e.g. -769
The Intake/Drain LED flashes 1x.
If faults are saved into memory,
these are indicated via the flashing
rhythm of the SaniWash LED.
Refer to 6.7 Fault code summary.
The SaniWash LED is off = F0 (no
faults).
The Intake/Drain LED flashes 2x.
The flashing rhythm of the
SaniWash LED indicates which
component is currently accessed.
For the sequence of component
testing as well as backgraound
information and access
procedures, refer to 6.3.2.3
Component test.
Technical Information
Flashing rhythm of
SaniWash LED
Long Short
- - ID No.
- - F0
- 1 F1
- 2 F2
1 1 F11
1 2 F12
1 3 F13
1 4 F14
1 8 F18
1 9 F19
2 4 F24
2 5 F25
2 6 F26
4 - F40
5 1 F51
5 2 F52
6 9 F69
7 - F70
8 8 F88
- - U0
- 1 U1
- 2 U2
- 3 U3
- 4 U4
- 5 U5
- 6 U6
- 7 U7
- 8 U8
- 9 U9
1 0 U10
1 1 U11
1 2 U12
1 3 U13
1 4 U14