Table 6-16: Service Mode (G2170) (Continued From Table 6-15) - Miele G1000 Technical Information

Technical Information
Flashing
rhythm of
Function
Intake/Drain
LED
Pos 4:
Long Short
Operating
hours
check
- 3
Pos. 5:
Control
Panel LED
test
- 4
Pos. 6:
Control
Panel
Buzzer
Test
- 5

Table 6-16: Service Mode (G2170) (Continued from Table 6-15)

*1 To make the desired setting adjustments. Hold the Program button until the Intake/Drain
Lt. is blinking, then use the Program button to make your setting changes. Once done, hold
the Program button until the Intake/Drain Lt. is solid again.
Save and quit
Switch off the unit.
Programming
Press the Program
button 3x.
To check the operating
hours, press the
Program button and hold
until the Intake/Drain
LED flashes. Then press
the Program button
briefly. *1
Press the Program
button 4x.
To start the control panel
test: LED, press the
Program button and hold
until the Intake/Drain
LED flashes. Then press
the Program button
briefly. *1
Press the Program
button 5x.
To start the control panel
test: Buzzer, press the
Program button and hold
until the Intake/Drain
LED flashes. Then press
the Program button
briefly. *1
126
G1000 / G2000 Dishwashers
Indication
The Intake/Drain LED
flashes 3x.
The flashing rhythm of the
SaniWash LED indicates
the saved operating hours.
Each long flash of the
SaniWash LED represents
1000 hours and each short
flash 100 hours.
The Intake/Drain LED
flashes 4x.
All LEDs are lit.
The Intake/Drain LED
flashes 5x.
Buzzer on.
Flashing
rhythm of
SaniWash
LED
Long Short
- -
- -
- -