Table of Contents
Advertisement
(3) Cable insertion
Lift up the tail of the plug cover, and fully insert a cable.
Insert different signal wires to the one-touch
communication connector plug as shown in the right
figure.
NOTE
• Insert the cable fully. Failure to do so may cause a crimping failure.
• A cable sometimes comes out of the head of the cover. In that case, pull the cable a little so that the cable stays under
the plug cover.
(4) Crimping the plug cover
Push the plug cover onto the plug with a tool such as pliers. After crimping, check that the plug cover is
securely snapped into the plug as shown in the right figure.
NOTE
• Misaligned latches between the plug cover and the plug may keep the cover lifted. The plug
cover is not sufficiently crimped in this condition. Push the plug cover until it snaps into the plug.
18
WIRING
5 4 3 2 1
Signal name
DA (Blue)
DB (White)
DG (Yellow)
Not used
SLD (Drain wire)
Hide quick links:
Advertisement
Table of Contents
