Wiring; Connecting The Cc-Link Dedicated Cable; Fabricating The Connection Cable - Mitsubishi Electric FR-A8NC Instruction Manual

3

WIRING

3.1

Connecting the CC-Link dedicated cable

3.1.1

Fabricating the connection cable

In the CC-Link system, use CC-Link dedicated cables.
If the cable used is other than the CC-Link dedicated cable, the performance of the CC-Link system is not guaranteed.
For the specifications of the CC-Link dedicated cable, refer to the website of the CC-Link Partner Association.
• Website of the CC-Link Partner Association http://www.cc-link.org/
• One-touch communication connector plug (as of July 2013)
Refer to the following table for the plug required to fabricate a cable on your own.
Model
A6CON-L5P
35505-6000-B0M GF
(1) Cable-end treatment
Apply the following treatment to the CC-Link dedicated cable that is inserted to a one-touch communication connector plug.
1. Cut the sheath
16
WIRING
Manufacturer
Mitsubishi Electric Corporation
Sumitomo 3M Limited
2. Separate shielding wires from the drain wire. Cut the shielding wires.
Drain wire
Shielding wires