Fujitsu PRIMERGY CX400 S1 Upgrade And Maintenance Manual page 55

Figure 16: Removing the power distribution module (A)
Ê Disconnect all power cables from the boards:
– Cable C1 and C2 from the HDD backplanes
– Cable C4, C6 and C7 from the midplane
Ê Slide the power cables trough the recess to get access to the screws.
Ê Disconnect the fan cable C3 from the bottom PDB (1), see also
on the PDB" on page
Ê Remove two screws (2).
I
For information about the cabling refer to chapter
CX400 S1
135.
Upgrade and Maintenance Manual
Basic hardware procedures
"Connectors
"Cabling" on page 191.
55