Removing The Server Node Dummy Module - Fujitsu PRIMERGY CX400 S1 Upgrade And Maintenance Manual

Basic hardware procedures
4.5

Removing the server node dummy module

I
The CX400 S1 system must always run with closed node bays. It is only
allowed to leave a bay open for a limited time in case of repairing a server
node (for example). In this case the node bay must be closed within one
hour. In the meantime all remaining server nodes run in throttling mode
(with reduced performance).
V
CAUTION!
Follow the safety instructions in the chapter
●
on page
Figure 9: Removing the server node dummy module
Ê Undo the locking mechanism (1) of the release lever and pull the server
node dummy module out of the slot (2).
50
31.
Upgrade and Maintenance Manual
"Important information"
CX400 S1