Operation Volume Creation; Figure 5.9 Operation Volume Creation; Table 5.2 Operation Volume Creation - Fujitsu ETERNUS DX200 S3 Configuration Manual

Chapter 5 General Settings
5.7 RAID Configuration Settings
5.7.2

Operation Volume Creation

Create volumes (areas in the drives of a RAID group) in the RAID group.
Create a 1TB Standard volume in the operation RAID group created in

Figure 5.9 Operation Volume Creation

Operation RAID group (RG0)
600GB
600GB
600GB
RAID5 (4+1)
To perform backup with SnapOPC+, two types of volume for backup (generation data management area and
temporary work area) must be prepared in addition to the one for operation. For details about creation of
backup volume, refer to
porary Work Volume (SDPV) Creation" (page

Table 5.2 Operation Volume Creation

Usage
Operation volume (copy
source)
Generation management
volume
Temporary work volume
*1: Though the copy source capacity is specified during creation, the capacity allocated to sdv is approxi-
mately 0.1% of the copy source capacity.
When creation is finished, the volume is automatically formatted. After volume creation, Standard and
SDV become accessible from the host when host affinity setting is completed.
SDPV becomes available when formatting starts after creation.
The procedure to create an operation volume is as follows:
1
Click the [Volume] tab on the navigation of the ETERNUS Web GUI screen.
The [Volumes] screen appears.
2
In [Action], click [Create].
The [Create Volume] screen appears.
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
600GB
600GB
"5.7.3 Generation Management Volume (SDV) Creation" (page 94)
Item
main
sdv0 - 6
sdpv
Copyright 2014 FUJITSU LIMITED
"5.7.1 RAID Group Creation" (page
Operation volume
1TB
main
(Standard)
95).
Capacity
1TB
1TB (*1)
500GB
92
88).
and "5.7.4 Tem-
Volume type
Standard
Snap Data Volume
Snap Data Pool Volume
P3AM-7652-02ENZ0