Rear; Figure 1.2 Front View Of A 3.5" Type Controller Enclosure; Figure 1.3 Rear Views Of A Controller Enclosure (When Only One Controller Is Installed) - Fujitsu ETERNUS DX200 S3 Configuration Manual

Chapter 1 Component Names
1.1 Controller Enclosures
■
3.5" Type

Figure 1.2 Front View of a 3.5" Type Controller Enclosure

1 2
3
1. Operation panel
2. 3.5" drive
3. Flange cover
1.1.2

Rear

This section provides the names of the components in the rear of a controller enclosure.
When only one controller is installed
•

Figure 1.3 Rear Views of a Controller Enclosure (When Only One Controller is Installed)

1
3
1. Controller (CM#0)
2. Cover
3. PWC port
4. Host interface (CA#0)
5. Drive interface (OUT) port
6. LAN (RMT) port
7. Host interface (CA#1)
8. LAN (MNT) port
9. Power supply unit (PSU#0)
10. Power supply unit (PSU#1)
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
4 5 6 7 8
9
Copyright 2014 FUJITSU LIMITED
2
10
19
3
P3AM-7652-02ENZ0