Fujitsu ETERNUS DX200 S3 Configuration Manual page 40

Chapter 2 Rack Installation
2.4 High-density Drive Enclosure Installation (for Regions Other than EMEA&I)
Insert the M4 screws in the second holes on the front and rear rack pillars above the base line to
fasten the rack rails.
2nd hole
(M4 screw)
3
Install the stopper bracket (for left side) and the stopper bracket (for right side).
Attach the stopper bracket to the front rack pillar.
Stopper bracket
(left)
M5 screw
The M5 screw positions for the stopper brackets are determined by the high-density drive enclosure
base line.
Insert the M5 screws in the seventh holes above the base line to fasten the stopper brackets.
7th hole
(M5 screw)
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
High-density drive enclosure
Front/Rear
[Left]
4U
High-density drive
enclosure base line
Rack rail
Rack rail
(left)
M5 screw
(Rack pillar: front)
High-density drive enclosure
Front
[Left]
4U
High-density drive
enclosure base line
Rack rail
Copyright 2014 FUJITSU LIMITED
[Right]
2nd hole
(M4 screw)
(Rack pillar: rear)
Rack rail
(right)
Stopper bracket
(right)
[Right]
7th hole
(M5 screw)
40
P3AM-7652-02ENZ0