Fujitsu ETERNUS DX200 S3 Configuration Manual page 41

Chapter 2 Rack Installation
2.4 High-density Drive Enclosure Installation (for Regions Other than EMEA&I)
4
Install the flap brackets.
Attach flap bracket A and B on the right side of the rear rack pillar with the M4 screws.
Stopper bracket B
M4 screw
(Rack pillar: rear)
The M4 screw positions for flap bracket A and B are determined by the high-density drive enclosure
base line.
Insert the M4 screws in the seventh and eighth holes above the base line to fasten the flap brackets.
Rear view of a high-density drive enclosure
[Left]
4U
5
Install the high-density drive enclosure in the rack.
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Rack rail
(right)
Stopper bracket A
[Right]
Flap bracket B
High-density drive
enclosure base line
Rack rails
Do
To keep it safe and stable, use a lifter to install or remove high-density drive
•
enclosures in racks.
Copyright 2014 FUJITSU LIMITED
(Rack pillar: front)
Rack rail
(left)
7th & 8th
holes
(M5 screws)
41
P3AM-7652-02ENZ0