Installing Power Distribution Unit (2U) - Fujitsu ETERNUS DX200 S3 Configuration Manual

Chapter 2 Rack Installation
2.1 Installing Power Distribution Unit (for Regions Other than EMEA&I)
2.1.2

Installing Power Distribution Unit (2U)

This section explains how to install a 2U power distribution unit (12 outlet type or 16 outlet type) in a rack.
This section explains how to install a 12 outlet type power distribution unit as an example. This installa-
tion method can also be applied to a 16 outlet type power distribution unit.
1
Attach the M5 cage nuts to the rear rack pillar.
Attachment positions
•
On either side, insert eight M5 cage nuts in the 1st, 3rd, 4th, and 6th holes above the power distribu-
tion unit base line.
M5 cage nut
6th hole
4th hole
3rd hole
1st hole
• Attachment procedure
Clip the M5 cage nut tabs into the desired hole from the inside.
Side view
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
(Rack pillar: rear)
[Left]
1U Power distribution unit
2U
1U Power distribution unit
Power distribution unit
base line
M5 cage nut
Rack pillar (square hole)
Copyright 2014 FUJITSU LIMITED
M5 cage nut
[Right]
6th hole
4th hole
3rd hole
1st hole
30
P3AM-7652-02ENZ0