Voice Control (Dnx9140 Only) - Kenwood DNX9140 Instruction Manual

• ASR on the Language Setting screen should be set to "Enabled". See <Language Setting> (page 68).
Voice Control
D
Enter into the Voic:e control mode
Press the TALK switch.
The voice recognition icons will be attached to
the buttons supporting the voice control.
H
Speak the command
Speak the command. (Ex: Speak "Source Select".)
You will hear a beep.
The screen has changed to the Source Control
screen.
You will hear a beep again.
II
Speak the command
Speak the command. (Ex: Speak "TUNER".)
You will hear a beep.
The screen has changed to the Tuner Control
screen.
You will hear a beep again.
a
Control the source with voice control
Repeat the same procedure as step 2 or 3.
For information on the recognizable voice
commands, refer to <Voice command table>
(separate volume).
D
End the voice control mode
Press the TALK switch.
Q
~
• The voice control is disabled while operating the hands-
free phone.
• The voice control is disabled when
~
is displayed on the
upper-right corner of the screen.
• The voice control is canceled when the screen is touched
or any of the buttons, except the [VOLUME] button, on
the front panel or the remote control unit is pressed.
• The voice control is disabled while using your cell-phone
with hands-free.
• The voice control is canceled if no operation is continued
for a certain period of time.
Tips for voice command
The voice recognition icons are displayed on
the operation buttons on the screen when the
voice control mode is turned on. The icons are
divided into two types: the number icon (such
asU.) for the list buttons, and the icon
~
for the
operation buttons. The command name may be
displayed.
English 47