Getting Started; How To Set A Medium A Device - Kenwood DNX9140 Instruction Manual

Getting Started
Press the
[~]
button for. more than 1 second
to opert the front panel. . .
Inserting the SO card
Hold the SO card with the label side up
and the notched section on the right, and
insert it into the sloful1til it clicks.
Removing the SO card
Push the SO card until it clicks and then
remove your finger from the card. The card
pop~up
so that you can pull it out with
youdlngers;
Press the
[~]
button to dose the front panel.
"• • The playback starts automatically after setting the media
Or the device.
• SO card (ONX9140 only)
This SO card slot is used to upgrade the
Navigation System.
For how to upgrade the Navigation System,
refer to the instruction manual of the
navigation system.
To disconnect the iPod, stop the playback
by touching the
[~II]
button on the source
control screen, and then disconnect the iPod.
See <Source Control Screen> (page 28).
Press the
[~]
button to open/close the front
panel.
If a disc is already inserted, it is ejected by,
pressing the
[~l
button.
• USB device
.iPod
How to Set a Medium
I
a Device
To disconnect the USB device, touch the
[~]
button on the source control screen, and
then disconnect the USB device. See <Source
Control Screen> (page 22).
English 13