Intercept Routing-No Destination; Internal Call Features; Internal Call Features-Overview - Panasonic KX-TDA100 Features Manual

1.1 Incoming Call Features
Feature References
1.3.1 Call Forwarding (FWD)/Do Not Disturb (DND)
1.1.1.6 Intercept Routing—No Destination
Description
Directs a CO line call to an operator when the call has no assigned destination.
Conditions
• Intercept Routing—No Destination on/off
Intercept Routing—No Destination can be enabled or disabled for the entire system, through system
programming. If disabled, the caller will hear a reorder tone.
Note that calls received through an LCOT or T1 (LCOT/GCOT) card will always be directed to an
operator, even when this feature is disabled.
• If an operator is not assigned:
The default intercept destination will be the extension connected to the lowest numbered port, on the
card installed in the lowest numbered slot.
• Intercept Routing—No Destination also applies to calls from doorphones.
Feature References
2.2.5 Operator Features
1.1.2

Internal Call Features

1.1.2.1 Internal Call Features—OVERVIEW
Description
There are two types of internal calls, described below.
Feature
Intercom Call
Doorphone Call
28 Feature Guide
Description
A call from one extension to another.
A call made from a doorphone to its preprogrammed
destination, assigned to the doorphone's port, for the
current time mode. (→ 2.2.4 Time Service)
Details in
• 1.5.3 Intercom
Call
• 1.15.1
Doorphone Call