Epson StylusPro 10000 Service Manual page 121

EPSON Stylus Pro 10000/10000CF
You may find it easy to remove the panel unit if you stand on the front
of the printer and use both hands to pull (squeeze) the panel towards
then lift up. (Refer the above figures and arrow directions. This way
you remove first the rear-side hook, then you can easily remove it.
2. Remove the FFC cable from the connector and hook.
Connector
FFC Cable
Figure 4-6. Panel Unit Removal 2/2
3. Remove nine screws then remove the panel board.
Disassembly & assembly
Hook
Figure 4-7.
When replacing the panel board and FFC, make sure you push the
FFC cable slack inside and towards the rear of the printer to avoid
interfering with carriage movement.
When installing the panel unit, place the grounding plate under the R-
side cover then push and lock it to the R side cover.
Disassembly Flow
Revision A
rth
121