Disassembly And Assembly; Summary; Warnings - Epson StylusPro 10000 Service Manual

EPSON Stylus Pro 10000/10000CF

4.1 Summary

This section describes the Disassembly and assembly methods for the EPSON Stylus Pro
10000/10000CF. However, full assembly instructions are not given apart from following
the Disassembly instructions in reverse order, and where special instructions are necessary,
reassembly points are provided.
Where "Caution" and "reassembly" notes are given, be sure to confirm these contents
BEFORE starting the corresponding procedure. Where adjustment procedures are
necessary, "Adjustment Required" notes describe what you need do to. These adjustment
procedures are absolutely necessary and are described in detail in Chapter 5.
Disassembly & assembly

4.1.1 Warnings

Before proceeding with any Disassembly or assembly work, make absolutely sure of the
following.
n
The power switch is located on the control panel. Any time the
printer is plugged into a power outlet, power is suppling through
the PS board. Unless otherwise stated, always turn off the
printer, wait several seconds, and then unplug the power cable
from the outlet before servicing a printer.
n
For safety reasons, the front cover position is automatically
detected by the cover-open sensor which is an interlock switch.
Do not block or modify this sensor.
n A lithium battery is installed on the MAIN Board of this
printer. Be sure to observe the following instructions when
servicing the battery:
n
Keep the battery away from any metal or other batteries so that
electrodes of the opposite polarity do not come in contact with each
other.
n
Do not heat the battery or put it near fire.
n
Do not solder on any part of the battery. (Doing so may result in
leakage of electrolyte from the battery, burning or explosion. The
leakage may affect other devices close to the battery.)
n
Do not charge the battery. (An explosion may be generated inside
the battery, and cause burning or explosion.)
n
Do not dismantle the battery. (The gas inside the battery may hurt
your throat. Leakage, burning or explosion may also be resulted.)
n
Do not install the battery in the wrong direction. (This may cause
burning or explosion.)
Summary
Revision A
114