Information; Input Source Information Display - Sanyo PDG-DXL2000 Owner's Manual

Information

Input Source Information Display

The Information Menu is used for checking the status of the image signal being projected and the operation of
the projector.
Direct Operation
The information menu changes each time you press the
INFO. button on the remote control as follows.
page 1/2 page 2/2
While the information menu is displayed, press the Point
buttons to display the previous or next page.
Menu Operation
Press the Point
Information Menu is displayed.
See below for displayed information.
Information Menu
Input
H-sync freq.
V-sync freq.
Screen
Language
Lamp status
Lamp counter
Power management
Key lock
PIN code lock
Remote control
SERIAL NO.
hide page 1/2
buttons to select the Information. The
The selected input source is displayed.
The horizontal frequency of the input signal is displayed in KHz, or - - - -KHz when
no signal.
The vertical frequency of the input signal is displayed in Hz, or - - - - Hz when no
signal. Numbers of Hz doubles when during Interlace.
The selected screen size is displayed.
The selected language is displayed.
The selected lamp mode is displayed.
The cumulative lamp operating time is displayed.
Off, Ready, Shut down or Timer is displayed.
The selected Key lock icon is displayed.
Off or On 1 or On 2 is displayed.
The selected remote code is displayed.
The serial number of the projector is displayed. The serial number is used to service
the projector.
Remote Control
• • • • •
INFO. button
63