Connecting The Power Supply; Installing Or Replacing The Paper Roll - Samsung SRP-370 User Manual

1-5. Connecting the Power Supply

CAUTIONS:
When connecting or disconnecting the power supply from the printer, make sure that
the power supply is not plugged into an electrical outlet. Otherwise you may damage
the power supply or the printer.
If the power supply's rated voltage and your outlet's voltage do not match, contact
your dealer for assistance. Do not plug in the power cord. Otherwise, you may damage
the power supply or the printer.
1. Make sure that the printer's power switch is turned off, and the power supply's
power
cord is unplugged from the electrical outlet.
2. Check the label on the power supply to make sure that the voltage required by the
power supply matches that of your electrical outlet.
3. Plug in the power supply's cable as shown below. Notice that the flat side of the
plug faces down.
Notes : To remove the DC cable connector, make sure that the power supply's power
cord is unplugged; then grasp the connector at the arrow and pull it straight out.
8

1-6. Installing or Replacing the Paper Roll

Notes : Be sure to use paper rolls that meet the specifications. Do not use paper rolls
that have the paper glued to the core because the printer cannot detect the
paper end correctly.
1. Make sure that the printer is not receiving data; otherwise, data may be lost.
2. Open the paper roll cover by pressing the cover-open button.
Notes : Do not open the print cover while the printer is operating.
This may damage the printer.
3. Remove the used paper roll core if there is one.
4. Insert the paper roll as shown.
9