Panasonic WJ-SX550A Operating Instructions Manual page 60

Connection with the System Controllers
• Data Line and Unit Number Setting
Up to eight WV-CU550A System Controllers may be
installed in a Matrix System.
The Control Board installed in the WJ-SX550A Matrix
Switcher has eight ports that correspond to eight WV-
CU550A System Controller inputs.
If the supplied 6-conductor cable assembly is used,
simply plug one end of the cable into a port on the
Control Board and other end into one of the ports on
the rear of the System Controller.
• Mode Selection Switch Setting
The Mode Selection Switch, that selects the operation
mode of the System Controller, is located on the rear
of the System Controller Select the switches to meet
the system shown below.
Normal Mode
CAM-P Mode
4
Normal Mode: Selects the menus except the CAM-P
(D5) Menu on the LCD.
CAM-P Mode: Selects the CAM-P (D5) Menu on the
LCD included menus at the Normal Mode. Select
this mode if operating the Camera Position func-
tions.
Select the mode before turning the System Controller
power on.
The selected mode is fixed to turn the System
Controller power on. Initially, Normal Mode is selected
at the factory.
MODE
OFF
ON
MODE
OFF
ON
If the cable to be used is assembled from locally pro-
cured materials it is important that only high quality,
data grade cable, suitable for RS-485 (2 shield, twist-
ed pairs) is used.
Low grade cable will result in unstable operation of the
system.
-56-