Panasonic WJ-SX550A Operating Instructions Manual page 121

16. Priority Lock
This function is used to retain control of a monitor by an
operator, even after that operator has selected another
monitor or has logged out.
1. Select the Priority Lock (A4) Menu on the LCD by
pressing the appropriate Cursor Keys.
2. Press the Function (F1) Key to select the Priority Lock
mode. The monitor number is inversely displayed on
the selected monitor, as shown below.
A4
PriorityLock
On Off P Auto Log-Out
F1 F2 F3 F4
3. Press the Function (F2) Key to release the priority
lock, the monitor number is displayed normally on the
monitor.
Note: This function will prevent operators with a lower
priority from gaining control of a monitor.
However, higher priority operators may still gain
control of that monitor.
17. Log-Out
This function is used when an operator is leaving the con-
troller, or no longer requires access to the system.
Controlling any functions from this controller is restricted
until an operator logs in.
1. Select the Log-Out (A4) Menu by pressing the appro-
2. Press the Function (F4) Key to log out. The LCD dis-
M16
• Auto Log-in Setting
If an operator was made the Auto Log-in setting to On
mode before Log-Out, any operator can be Log-in auto-
matically and control as an operator previously.
Select either mode On or Off to meet the systems.
1. Select the Log-Out (A4) Menu by pressing the appro-
2. Press the Function (F3) Key repeatedly to select Auto
-117-
priate Cursor Keys.
play shows the Log-in Display.
A4
PriorityLock
On Off Auto Log-Out
P
F1 F2 F3 F4
Log-in
priate Cursor Keys.
A4
PriorityLock
On Off Auto Log-Out
P
F1 F2 F3 F4
Log-in mode On or Off.
On: Auto
Off: Auto
6