Panasonic WJ-SX550A Operating Instructions Manual page 118

14-4. Home Position Setting
After selecting the SET HOME POSI sub menu, a table
titled HOME POSITION, appears on the monitor.
CAM
1. Move the cursor to the HOME POSITION by moving
the Joystick Controller, and enter the desired position
number by pressing the Numeric Keys.
2. Move the cursor to the AUTO HOME POSITION by
moving the Joystick Controller, and select either mode
Off or a desired time by pressing the Increment
Switch or Decrement (DEC) Switch.
3. Press the Set (SET) Key to execute the selection, and
to return to the Preset Program Menu.
Note: The auto home position function, when enabled,
will return the camera to the designated home
position automatically after a predetermined peri-
od of time.
14-5. Preset Test Mode
6
After selecting the PRESET TEST sub menu, the following
screen appears on the monitor.
CAM
POSITION NUMBER : 12
1. Press the Set (SET) Key to activate the test mode, the
selected camera goes to all preset positions, starting
from the lowest preset number to the highest preset
number. The above function will automatically stop
after ten minutes.
2. Press the Escape (ESC) Key to stop the preset test
mode.
3. Press the Escape (ESC) Key again to return to the
Preset Program Menu.
: CameraTitle
*HOME POSITION*
1 HOME POSITION : 15
2 AUTO HOME POSITION
: 10MIN
: CameraTitle
TEST
ESC STOP
14-6 Clear the Preset Settings
1. Select the desired camera and monitor.
Refer to the Camera Selection and Monitor Selection
on page 98.
2. Select the Preset (D3) Menu on the LCD by pressing
the appropriate Cursor Keys.
3. Press the Function (F1) Key to select the Preset
Program Mode.
The Preset Program Menu appears on the selected
monitor and selected menu as shown below on the
LCD.
(INC)
4. Move the cursor to "SET UP PRESET" by moving the
Joystick Controller, then press the Set (SET) Key to
select a table titled "PRESET NUMBER SET" on the
monitor.
5. Move the cursor to the desired preset number by mov-
ing the Joystick Controller, then press the Set (SET)
Key to select the Preset Position Setting table as
shown below.
6. Press the Function (F1) Key to clear the preset set-
tings on the selected preset number.
If only clear the BLC setting, press the Set (SET) Key
to select the Preset BLC Setting table, then press the
Function (F2) Key instead of step 6.
-114-
D3
Preset Menu:CS500
On Refresh
F1 F2 F3 F4
Preset/BLC Clear
Pre BLC
F1 F2 F3 F4
CAM : CameraTitle
POSITION NUMBER : 12
PAN/TILT/ZOOM/FOCUS
SET UP POSITION
Preset/BLC Clear
Pre BLC
F1 F2 F3 F4