Securing The Plasma Display To The Wall; Securing The Plasma Display To A Desk Or Floor - Sharp PZ-MR2X Operation Manual

Preparation
2
Commercially
available
Securing bracket
Desk
1
In the case of
PZ-50HV2
1
In the case of
PZ-43HV2
2
1
Soft cloth
(rear view)
4
Securing the Plasma Display to the
wall
1
Fasten the two supplied eyelet screws.
2
Thread a suitable wire or rope through the eyelet
screws, and attach this to the wall at both sides.
Make sure that the Plasma Display is firmly
installed to the wall.
A
• The wire, rope and suitable fixings for these are available
commercially .
• The eyelet screws fit on different locations depending on
the Plasma Display screen size.
In the case of PZ-50HV2
In the case of PZ-43HV2
Securing the Plasma Display to a desk
or floor
The unit can also be secured via the stand.
1
Cover a desk with a suitable soft cloth, and place
the Plasma Display on its side.
2
Attach the securing bracket as shown, using the
supplied screws.
3
Stand the unit upright and place in position.
4
Secure the unit to the desk or floor as shown in
the diagram, with suitable fixings (commercially
available).
E-10