Sharp PZ-MR2X Operation Manual page 72

HOW TO SET THE FACTORY PRESETS
Press and hold down CLEAR on the AVC System while it is in standby mode. Then press POWER on the
Plasma Display or B on the remote control unit to turn the Plasma Display TV on.
All setting items (except TV channel) return to the factory presets.
A
• Running the factory preset operation also clears the password.
You can run the Auto Installation again by using the following steps.
1
Turn on the power of the Plasma Display and the AVC System.
2
Press MENU. (Make sure the menu screen displays.)
3
Press b to select "Setup".
4
Press ENTER.
A
• If the password setting screen displays, you need to enter your password.
• If you forget your password, refer to HOW TO SET THE FACTORY PRESETS above.
5
Press a/b to select "Auto Installation".
6
Press ENTER.
"Auto Installation completed." displays. After that, the screen changes to the TV mode.
The password is
A
• As a precautionary measure, make a note of your password above, scissor it from this manual, and keep it in a familiar
place.
E-71
.