Replacing The Internal Speaker - Lenovo 10B0 Maintenance Manual

Replacing the internal speaker

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
on page 1.
This section provides instructions on how to replace the internal speaker.
To replace the internal speaker, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 211.
3. Locate the internal speaker in the computer. See "Locating major FRUs and CRUs" on page 85.
4. Remove the hard disk drive assembly. See "Installing or removing the hard disk drive assembly" on
page 213.
5. Disconnect the internal speaker cable from the system board.
6. Release the internal speaker cable from the retaining clip on the side of the thermal module bracket.
Figure 193. Releasing the internal speaker cable
.
Chapter 11 Replacing FRUs (machine types: 10AX and 10AY)
225