Replacing The Hard Disk Drive - Lenovo 10B0 Maintenance Manual

11. Use the Setup Utility program to set the date, time, and any passwords. See Chapter 6 "Using the Setup
Utility program" on page 57.

Replacing the hard disk drive

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
on page 1.
This section provides instructions on how to replace the hard disk drive.
To replace the hard disk drive, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 136.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 136
4. Note the location of the four screws
assembly upward.
Figure 81. Pivoting the drive bay assembly
1
that secure the hard disk drive. Then, pivot the drive bay
.
Chapter 10 Replacing FRUs (machine types: 10B4, 10B5, 10B6, and 10B7)
145