Notice Page Printing; Disabling Notice Page And Separator Sheet Printing; Troubleshooting - Sharp AR-PB2 Operation Manual

Digital copier printer expansion kit

Hide thumbs Also See for AR-PB2:

Table of Contents

Notice Page Printing

If you find that a notice page has been printed at the end of a print job, the length of the document

exceeded the printer memory capacity as described above. The print data received from the

computer has not been printed as specified. Check the print order and arrange the order if needed.

If the specified number of copies have not been output, you have remedies: 1) Print again sending

the job to the printer multiple times. 2) Change the key operator program "Output Method When

Memory Is Full" to "MULTI-SET".

Notice page and separator sheet printing can be disabled using a key operator program. See page

38, "Prohibit Notice Page Printing".

Problem: Printer does not operate.

Check:

Is the printer plugged in?

Solution: Plug the printer into a grounded outlet.

Check:

Is the power switch on?

Solution: Turn the power switch on.

Problem: Printer is on but data is not received. (Data indicator does not blink.)

Check:

Is the printer set to the ONLINE mode?

Solution: Use the "ONLINE/OFFLINE" key on the touch panel to select the "ONLINE" mode.

(page 34)

Check:

Is the correct printer cable properly connected between the printer and your computer?

Solution: Check both ends of the printer cable and make sure you have a solid connection. Try a

known good cable.

Check:

Is the correct printer driver installed?

Solution: Install the appropriate printer driver. (page 5)

Check:

Is the printer not selected properly or not registered with the network?

Solution: Ensure that this printer is selected on the application software or the printer is registered

on the network.

PRINTER TROUBLESHOOTING

Table of Contents