Printing Documents From The Computer; Fonts - Sharp AR-PB2 Operation Manual

Printing Documents from the Computer

In most cases, it is not necessary to use the operation panel when printing documents from the
computer. When a document is sent to the printer from the computer, the printer will automatically
print the document. However, following the procedure specified below can help ensure that
documents are printed accurately. The procedure assumes that the printer has been properly
connected to a computer as described in Chapter 1, and that a printer driver has been installed as
described in this chapter. For more information regarding the printer operation panel, refer to
Chapter 4.
1. Check the operation panel to confirm that the ON LINE indicator is lit. If the ON LINE indicator is
not lit, press the PRINT key to select the printer mode and then press the "ONLINE" key on the
touch panel to set the printer to the on-line condition.
2. Check the paper tray(s) to ensure that the desired paper is loaded.
3. Using the computer and any appropriate application software, load the document to be printed, set
any desired features using the installed printer driver, and give the command to print the document.
If necessary, refer to the documentation for the computer and/or the application software for help
on issuing the necessary commands.
4. The printer will print the document.

Fonts

Refer to Table 7-1 and Table 7-2 for a complete list of fonts resident in the printer for use by the
supplied printer drivers.
The resident fonts are always available to the printer and need not be downloaded with each print
job. Using the resident fonts enables the printer to operate at maximum performance, and reduces
the amount of data which must be transferred from the computer to the printer with each print job.
PRINTING FROM A COMPUTER
13