Enable Bypass-Tray Size Detection; Prohibit Notice Page Printing - Sharp AR-PB2 Operation Manual

USING THE OPERATION PANEL
Separator
sheet
1 block
Example: One set of 120-page document is
printed in 60-page blocks.

Enable Bypass-Tray Size Detection

This program is used to enable or disable paper size detection of the bypass tray in the printer
mode. This setting does not affect the paper size detection in the copier mode.
To enable paper size detection of the bypass tray in the printer mode, press the "ENABLE
BYPASS-TRAY SIZE DETECTION" box to display a check mark.
To disable paper size detection, press the checked box again to clear the check mark.
NOTE If size detection of the bypass tray is disabled, paper in the bypass tray will always be treated as the largest allowable
size paper (either 11" x 17" or A3). If an image larger than the paper in the bypass tray is printed, a malfunction may
occur. Be careful when disabling the size detection.

Prohibit Notice Page Printing

This program is used to specify whether a notice page and separator sheets will be printed when
the printer memory becomes full and divided printing must be performed. If notice page printing has
been enabled, a notice page will be printed at the end of a print job and separator sheets will be
printed between each block letting the user know that the job has been divided into blocks and the
user must re-stack the document.
To prohibit notice page printing, press the "PROHIBIT NOTICE PAGE PRINTING" box to display a
check mark.
To restore notice page printing, press the checked box again to clear the check mark.
Separator
Notice page
sheet
Separator
Page 61
sheet
Page 120
Page 1
Separator
sheet
Page 60
1 block
Example: Two sets of 120-page document are
38
printed in 60-page blocks.
Notice page
Page 61
Page 120
Page 61
Page 120
Page 1
Page 60
Page 1
Page 60