Network Settings; Print Test Page - Sharp AR-PB2 Operation Manual

USING THE OPERATION PANEL

Network Settings

Use the network settings when using this printer as a network printer. If an optional network
interface card (Print Server Card) is not installed, these settings will not appear on the touch panel.
ENABLE TCP/IP
IP ADDRESS SETTING
ENABLE NetWare
ENABLE EtherTalk
(TokenTalk)
When the enable or disable setting of protocols (ENABLE TCP/IP, ENABLE NetWare, and ENABLE EtherTalk) is
NOTE
changed, the new setting will be effective after resetting the printer. For resetting, follow the message by pressing "OK",
turning the printer off and then back on after waiting a few seconds.

Print Test Page

Printing a test page verifies that the printer operates properly. Also you can check the configuration
settings, built-in fonts etc. When printing is complete, the printer will exit the printer configuration
menu and return to online mode.
PRINT CONFIGURATION
PAGE
PRINT RESIDENT FONT
LIST
PRINT DEMO PAGE
PRINT NIC PAGE
Enables or disables the TCP/IP protocol. This setting is enabled in the default
setting. To use the printer with the TCP/IP protocol, set the IP address in
the next function.
IP ADDRESS: Manually set the printer's IP address. Note that no number can
exceed 254. First digit of the number cannot be 0. Each item can be selected
directly with the touch key. The value can be input using the 10-key pad.
IP SUBNET MASK: Manually set the printer's IP subnet mask. Note that no
number can exceed 255. First digit of the number cannot be 0. Each item can
be selected directly with the touch key. The value can be input using the 10-
key pad.
IP GATEWAY: Manually set the printer's IP gateway. Note that no number can
exceed 254. First digit of the number cannot be 0. Each item can be selected
directly with the touch key. The value can be input using the 10-key pad.
Enables or disables the NetWare protocol. This setting is enabled in the
default setting.
Enables or disables the EtherTalk (TokenTalk if TokenRing network is
connected) protocol. This setting is enabled in the default setting.
If this key is pressed, the printer will return to the online mode and print the
configuration list.
If this key is pressed, the printer will return to the online mode and print the
resident font list.
If this key is pressed, the printer will return to the online mode and print a
demonstration page.
If this key is pressed, the printer will return to the online mode and print the
NIC (Network Interface Card) configuration page. If an optional network
interface card (Print Server Card) is not installed, this function will not
appear on the touch panel.
32