Memory Reserved For Printer; Output Method When Memory Is Full - Sharp AR-PB2 Operation Manual

Memory Reserved for Printer

This program is used to specify the percentage of document memory allocated to storage of printer
jobs. In the default setting, the memory capacity for printer jobs is 30% (60 pages for A4 or 8-1/2" x
11"). To print documents that exceed this limit, increase the percentage using this program.
When the "MEMORY RESERVED FOR PRINTER" key is pressed, the following display will appear.
This program can be used only for models with a 1 GB hard disk drive. For models with a 2 GB hard disk drive or no
NOTE
hard disk drive, this program cannot be used.
KEY OPERATOR PROGRAMS
MEMORY RESERVED FOR PRINTER
30%
45%
60%
NOTES If '30%' is specified, the maximum number of pages in a block is 60 for A4, letter or smaller sizes. If '60%' is
specified, the maximum number is 120 for A4, letter or smaller sizes.
Since the memory in this printer is used for both copier and printer features, the setting of this program will affect
copying performance. Assign an appropriate value.

Output Method When Memory Is Full

When multiple sets of a document have been requested and the document memory cannot hold the
entire document, this program gives the option to print one set or multiple sets as illustrated on
page 38.
When the "OUTPUT METHOD WHEN MEMORY IS FULL" key is pressed, the following display will
appear.
KEY OPERATOR PROGRAMS
OUTPUT METHOD WHEN MEMORY IS
FULL
1 SET
MULTI-SET
NOTE When the document memory becomes full of print job pages, the printer will start printing the data which have been
stored in the memory. If multiple sets of the document have been requested and "MULTI-SET" is specified with this
program, the sets will be printed as shown below. Each set of printed sheets will be stacked offset from the previous
set. Finally, the printer will output a notice page unless it is prohibited with a key operator program.
OK
35% 40%
50% 55%
OK
USING THE OPERATION PANEL
1. Select the desired percentage.
2. Press the "OK" key.
1. Select "1 SET" or "MULTI-SET".
2. Press the "OK" key.
37