Motorola G24 Guide Developer's Manual page 588

AT Commands Alphabetical Summary
+ICF
+IFC
+IPR
+MADIGITAL
+MAFEAT
+MALARM
+MALMH
+MAMUT
+MAPATH
+MAVOL
+MCEG
+MCELL
+MCSAT
A-12
Table A-1: AT Commands (Alphabetical) (Cont.)
AT Command
This command determines the
local serial port start/stop
(asynchronous) character framing
used by the DCE when accepting
DTE commands and transmitting
information text and result codes,
whenever these are not done
automatically.
This command controls the
operation of the local flow
control between the terminal and
the G24.
This command is responsible for
setting and saving the request
baud rate.
This command switches between
analog and digital audio modes.
This command controls the
various algorithm features, such
as sidetone, echo cancel and
noise suppress.
This unsolicited event is sent to
the terminal indicating a
reminder is activated.
This command terminates the
current reminder.
This command controls the
muting/unmuting of all input
paths (MIC, HDST_MIC,
DIGITAL_RX).
This command sets/requests the
active input accessory, and the
output accessory for each feature.
This command enables you to
determine a volume setting for a
particular feature in a particular
accessory.
This command disables / enables
EDGE support in G24 modules
with EDGE support capability.
This command displays
information about the Cellular
Network.
This command
enables/disables/exercises SMS
alert tone for an arriving SMS.
AT Commands Reference Manual
Description
Page 3-205
Page 3-430
Page 3-195
Page 3-244
Page 3-243
Page 3-86
Page 3-87
Page 3-242
Page 3-237
Page 3-240
Page 3-356
Page 3-179
Page 3-137
Page
December 31, 2007