D, Circuit 108 Behavior - Motorola G24 Guide Developer's Manual

&D, Circuit 108 Behavior
This command determines how the G24 responds when the DTR (Data Terminal Ready) status is
changed from ON to OFF during the online data state. The DTR is an input line that indicates that
the terminal is ready.
The DTR line must be active (low) in order for the G24 to recognize the terminal. This signal is
raised by the terminal when a process activates the serial port. If the DTR is not used by the
application, it should connect this line to ground (DTR active). The default value is active (low).
In case of local link during initial PPP retries, DTR change will be ignored.
Set
Read
Test
The following table shows the &D parameters.
<Parameter>
<param>
Example
AT&D?
&D: 2
OK
AT&D1
OK
December 31, 2007
Command Type
Table 3-130: &D Parameters
The G24's reaction when the DTR status is changed from ON to OFF.
In CSD calls:
0,4 Ignores DTR changes
1 Switches the CSD call to asynchronous command mode (the call remains
connected)
2,3 Disconnects the call and returns to the command mode
In GPRS calls:
0,4 Ignores DTR changes
1 Switches the GPRS session to asynchronous command mode (the session
remains connected)
2,3 Deactivates the GPRS and returns to command mode
In MUX and MUX_INIT state:
0-3 Ignores DTE changes
4 Drops the MUX application and returns to PRE_MUX state
In Local link:
0,3,4 Ignores DTR changes
1,2 Stop Local link. Return G24 to command mode.
The default value is 2.
AT Commands Reference Manual
Chapter 3: AT Commands Reference
Syntax
AT&D<param>
AT&D?
AT&D=?
Description
Response/Action
OK
&D:<param>
&D:(list of supported <param>s)
3-201