GPRS/EDGE
EDGE Commands
Note:
+CGEQREQ, EDGE Quality of Service Profile (requested)
This command allows the TE to specify a EDGE Quality of Service Profile that is used when the
MT sends an Activate PDP Context Request message to the network.
Command
Type
Set
3-340
The following commands will be used only with G24 modules that support Edge.
Syntax
+CGEQREQ=[<cid>
[,<Traffic class>
[,<Maximum bitrate
UL> [,<Maximum
bitrate DL>
[,<Guaranteed bitrate
UL> [,<Guaranteed
bitrate DL>
[,<Delivery order>
[,<Maximum SDU
size> [,<SDU error
ratio> [,<Residual bit
error ratio>
[,<Delivery of
erroneous SDUs>
[,<Transfer delay>
[,<Traffic handling
priority> ]]]]]]]]]]]]]
AT Commands Reference Manual
Response/Action
OK
or:
ERROR
Remarks
The set command
specifies a profile for the
context identified by the
(local) context
identification parameter,
<cid>. The specified
profile will be stored in
the MT and will be sent to
the network only at
activation or MS-initiated
modification of the related
context. Since this is the
same parameter that is
used in the +CGDCONT
and +CGDSCONT
commands, the
+CGEQREQ command is
effectively an extension to
these commands. The
QoS profile consists of a
number of parameters,
each of which may be set
to a separate value. In
spite of this, not all
possible combinations are
allowed.
See Note 1 on
page
3-355.
A special form of the set
command, +CGEQREQ=
<cid> causes the
requested profile for
context number <cid> to
become undefined.
December 31, 2007