Cnmi, New Message Indications To Terminal - Motorola G24 Guide Developer's Manual

+CNMI, New Message Indications to Terminal

This command handles enabling of unsolicited notifications to the terminal when an SM is
received by the G24.
After sending an unsolicited response to the TE, the G24 will expect a +CNMA (new message
acknowledgement) from the TE within a predefined timeout of 60 seconds. The G24 will not send
another unsolicited response to the TE before the previous one is acknowledged. If acknowledged
within the timeout, the new SM is not saved in the message storage. If not, the new SM is saved
in the message storage and +CNMI parameters are set to 0.
Command Type
Set
Read
Test
The following table shows the +CNMI parameters.
<Parameter>
<mode>
<mt>
<bm>
<ds>
<bfr>
Example
AT+CNMI=?
+CNMI: (0,3),(0-2),(0,2),(0-2),(0)
OK
December 31, 2007
Syntax
+CNMI=[<mode> OK
[,<mt>[,<bm>
or:
[,<ds>[,<bfr>]]]]]
+CMS ERROR: <err>
+CNMI? +CNMI:<mode>,<mt>,<bm>,<ds>,<bfr>
+CNMI=? +CNMI: (list of supported <mode>s), (list of supported <mt>s),
(list of supported <bm>s), (list of supported <ds>s), (list of
supported <bfr>s)
Table 3-59: +CNMI Parameters
0 Buffer unsolicited result codes (default).
3 Forward unsolicited result codes directly to the terminal
0 No SMS-DELIVER indications are routed to the terminal (default)
1 If SMS-DELIVER is stored in the G24, the memory location indication is
routed to the terminal using the unsolicited result code: +CMTI:
<mem>,<index>
2 SMS-DELIVER is routed directly to the terminal
0 No CBM indications are routed to the terminal (default)
2 New CBMs are routed directly to the terminal
The CBM of multipage "CB" and "QuickView" are not supported.
0 No SMS-STATUS-REPORT indications are routed to the terminal (default)
1 SMS-STATUS-REPORT is routed directly to the terminal
2 If SMS-STATUS-REPORT is stored in the G24, the memory location
indication is routed to the terminal using the unsolicited result code: +CDSI:
<mem>,<index>
0 No SMS-STATUS reports are buffered.
AT Commands Reference Manual
Chapter 3: AT Commands Reference
Response/Action
Description
3-107