HP LC2000r - NetServer - 128 MB RAM Installation Manual page 71

Chapter 6
4. For both rack-mounted and pedestal models, follow the instructions in
Chapter 3, "Opening and Closing the HP NetServer," to gain access to the
I/O board.
NOTE
In the LH 6000r, this assembly is under the top cover; in the
LH 6000, it is under the left cover.
5. Consider the boot priority before installing any accessory boards.
For details, refer to the topic Boot Priority earlier in this chapter. If
installing a SCSI controller board, the controller's priority (boot order) is
set by the board's slot location.
6. Identify the desired slot (1 through 8), before installing the accessory board
(see Figure 6-1).
NOTE The PCI slot covers use the PCI hold-down latch and retainer
to hold the slot cover in place.
7. Release the PCI slot cover by rotating the locking lever clockwise to clear
the retainer (see Figure 6-2).
8. Remove the PCI slot cover from the NetServer's rear panel, before
installing the new board into the slot (see Figure 6-3).
9. Lift the retainer and remove the slot cover.
10. Remove the PCI front board hold down before installing the new PCI
board (see Figure 6-4).
Retainer
Locking
Lever
Figure 6-2. Opening the PCI Latch and Retainer
Installing Additional Boards
63