HP LC2000r - NetServer - 128 MB RAM Installation Manual page 131

Chapter 10
a password when booting from a hard drive. The power-switch and
keyboard will remain locked until the password is typed.
13. To use the front panel keyboard lock button, use the arrow keys to move to
the field:
14. Press Enter to toggle "Disabled" to "Enabled" in the Keyboard Lock field.
Setting this feature enables the keyboard lock button on the front bezel of
the HP NetServer. Once enabled, pressing the keyboard lock button will
lock the keyboard and mouse until the password is typed. You must set the
password before enabling this feature.
15. To add video blanking to the password on boot, use the arrow keys to
move to the field:
16. Press Enter to toggle "Disabled" to "Enabled" in the Video Blanking field.
Setting this feature only provides a blank screen on the HP NetServer's
Monitor, when the Keyboard Lock or Network Server Mode is also
enabled. The screen remains blank until the password is typed and only
applies to the monitor connected to the HP NetServer's embedded video
connection. As with the other features the Video Blanking is dependent
upon, you must set the password before enabling this feature.
17. Select the Esc key to exit this menu.
18. Use the right-arrow key to go to the Exit menu.
19. Choose Exit Saving Changes from the list of exit options, and then press
Enter.
A dialog appears and asks you to confirm your decision.
20. Choose Yes and then press the Enter key.
Then the HP NetServer reboots.
21. To change one of the passwords at a future date, return to the Security
menu and repeat Steps 3 through 7 above for one or both passwords.
NOTE The HP NetServer allows you to reset the password by toggling
a switch, position 6, in the Configuration Switch on the System
board.
"Keyboard Lock [Disabled]" .
"Video Blanking [Disabled]" .
Configuring the HP NetServer
123