HP LC2000r - NetServer - 128 MB RAM Installation Manual page 45

Chapter 3
4. Check that the four closely spaced metal tabs are in their four openings at
the rear of the HP NetServer. The cover is secure when all edges are flush
against the chassis and you cannot easily shift it.
5. Gently slide the cover until the rear edge snaps into place.
6. Tighten the thumbscrew at the front of the cover.
7. For the top cover, place the cover onto the chassis. Align the five tabs on
the left side of the cover with the slots in the chassis.
8. Slide the top cover back to the rear of the chassis and tighten the
thumbscrew.
9. Replace the bezel by placing the two tabs at the bottom of the bezel into
the corresponding slots on the chassis and snapping the bezel into position
at the top of the chassis.
10. Lock the bezel using the supplied key and remove the key from the front of
the NetServer.
Opening and Closing the HP NetServer
37