HP LC2000r - NetServer - 128 MB RAM Installation Manual page 65

Chapter 5
Figure 5-4. System Board Assembly on Grounded Anti-static pad
9. Identify the slot locations for the DIMM pair(s) being added:
10. Install the DIMM pairs:
a. Spread the latches outward on each slot receiving a DIMM.
b. Remove a DIMM from its anti-static bag, handling the module by its
edges.
c. Align the notches on the DIMM with the slot keys on the slot (see
Figure 5-5).
d. Press the DIMM into the slot until the latches close.
CAUTION
Do not rock the DIMM into place, but apply firm and even
pressure. If a gap exists between the retaining latches and the
DIMM, remove and replace the module until no gap exists.
Table 5-1. Paired Memory Slots
Slot 1A and Slot 1B
Slot 2A and Slot 2B
Slot 3A and Slot 3B
Slot 4A and Slot 4B
Installing Additional Memory
57