Chapter 8
Installing the HP NetServer in an HP Rack System/E or Rack System/U
10. Plug the HP NetServer's power cables and all available data cables into the
back of the HP NetServer.
Refer to the HP NetServer LH 6000r Rack Assembly and Cabling
Reference Guide for information about cable dressing and routing.
Attaching the Z-bracket for shipping
Should it be necessary to ship the system with the HP NetServer in place within
the rack, the Z-bracket should be attached to secure the HP NetServer to the rack
while shipping.
1.
Attach the Z-brackets to the rear columns with two Torx screws, using the
Torx T-25 driver. Fasten the bracket to the HP NetServer with two Torx
screws (see Figure 8-18).
2.
Secure the cable management arm to the right side rack column using the
cable tie provided in the Z-bracket kit.
3.
Use the original packaging, saved during installation, for packing and
shipping.
Figure 8-18. Attaching the Z-bracket to the HP NetServer and Rear Column
97