Table of Contents
Advertisement
Figure 14
Left side shown
1. Pivot frame hole
2. Washer
3. Hairpin cotter
6. Insert the bent ends of the rods into the attachment
mount as shown in
Figure 14
each rod with a washer and hairpin cotter.
4. Support rod
5. Keyed slot, existing
6. Bent, flared end of rod
and secure the end of
For 2011 through 2014 Models Only
Note: The stabilizer bracket is not used on 2011 through
2014 models.
Note: For 2011 through 2014 models, the rear-engine guard
is optional for this bagger.
1. Install the pivot frame to the machine frame as shown
in
Figure
15. Secure the pivot frame to the machine
frame using 2 bolts (5/16 x 1 inch) and 2 locknuts
(5/16 inch).
6
1
g032814
1. Machine frame
2. Locknut (5/16 inch)
3. Hole
2. Secure the pivot frame to the bottom of the machine
frame using 2 self-tapping screws (5/16 x 3/4 inch) as
shown in
Figure
9
2
3
4
Figure 15
4. Bolt (5/16 x 2-1/2 inch)
5. Pivot frame
6. Rear-engine guard
(optional)
16.
5
Advertisement
Table of Contents
