Installing The Attachment Mount; Keyed Cross Bar; Stabilizer Bracket (For 2015 And Newer Models); Carriage Bolt (5/16 X 3/4 Inch) - Toro 79393 Operator's Manual

G014879
Figure 8
1. Locknut (3/8 inch)
2. Weight bracket
3. Left mounting bracket
8. Install a flat weight to the weight bracket and move it
rearward, flush with the bracket
1
Figure 9

1. Keyed cross bar

2. Flat weight
9. Install a suitcase weight in front of the flat weight
(Figure 9).
2
1
3
4
5
4. Bolt (3/8 x 1 inch)
5. Right mounting bracket
(Figure 9).
2
3
G014880
3. Suitcase weight
10. Secure the weights to the weight bracket with a
keyed-cross bar
90 degrees downward to lock it in place.
11. After you install all the weights and brackets, check that
all the fasteners are tight. Tighten them as necessary.
Important: Whenever you remove the bagger
attachment, remember to remove the front weights to
return the proper stability to the machine.
2
Installing the Attachment
Mount
Parts needed for this procedure:
1

Stabilizer bracket (For 2015 and newer models)

2

Carriage bolt (5/16 x 3/4 inch)

4

Locknut (5/16 inch)

2

Self-tapping screw (5/16 x 3/4 inch)

2

Bolt (5/16 x 1 inch)

1

Pivot frame

2

Hairpin cotter

2

Rod

2 Washer
1 Draw-bar decal
For 2015 and Newer Models Only
Note: The stabilizer bracket is used only on 2015 and newer
models (Figure 10).
1. Install the stabilizer bracket to the engine guard using 2
carriage bolts (5/16 x 3/4 inch) and 2 locknuts (5/16
inch) (Figure 10).
7
(Figure 9). Install the bar and rotate it