Installing The Chute; Chute - Toro 79393 Operator's Manual

6

Installing the Chute

Parts needed for this procedure:
1

Chute

2 Knobs
2 Carriage bolt (5/16 x 1-3/8 inches)
2 Flange nut (5/16 inch)
2 Flat washers (5/16 inch)
Procedure
1. Remove the plate assembly that includes the side
discharge chute (Figure
assembly.
2. Remove the existing baffle under the right side of the
mower deck (Figure
3
4
3
Figure 24
1. Flange nuts
2. Plate assembly with
discharge chute
24). Save this hardware and
24). Save the baffle and hardware.
1
2
g017826
3. Carriage bolts
4. Existing baffle
Note: When installing the existing baffle, ensure the
correct holes are used for each bolt
3. Install the existing baffle with a carriage bolt (5/16 x 1
inch) and nut (5/16 inch) from the previously removed
baffle (Figure 25).
4. Use a new bolt (5/16 x 1-3/8 inches) and flange nut
(5/16 inch) to secure the inside of the baffle
25).
1
5
4
1. Existing flange nut (5/16
inch)
2. New flange nut (5/16 inch)
3. New carriage bolt (5/16 x
1-3/8 inches)
5. Install a carriage bolt and flange nut into the front hole
shown in Figure
6. Align the holes in the chute and install it onto the bolts.
Secure the chute to the mower deck with the two knobs
and flat washers (5/16 inch)
13
(Figure
2
3
Figure 25
4. Existing carriage bolt (5/16
x 1 inch)
5. Existing baffle
25.
(Figure 26).
25).
(Figure
g017823