Installing The Latch Rod; 1. Draw Bar Decal; Latch Rod; Hairpin Cotter - Toro 79393 Operator's Manual

1
Figure 16
1. Self-tapping screw (5/16 x
3/4 inch)
3. Attach the draw-bar decal 1.3 cm (1/2 inch) to the left
of the attachment mount
g030498
Figure 17

1. Draw bar decal

4. Install a bent, flared end of a rod into the keyed slot in
the left side of the machine frame, and move the rod
rearward to seat it in the frame
Note: Repeat this step for the right side of the
machine.
g030497
2
2. Pivot frame
(Figure 17)
1
(Figure 18).
2
1
4
6 5
1. Pivot-frame hole
2. Washer

3. Hairpin cotter

5. Insert the bent ends of the rod into the attachment
mount as shown in
each rod with a washer and hairpin cotter.
3

Installing the Latch Rod

Parts needed for this procedure:
1

Latch rod

1 Hairpin cotter
Procedure
Install the latch rod with a hairpin cotter
10
3
Figure 18
Left side shown
4. Support rod
5. Keyed slot (existing)
6. Bent, flared end of support
rod
Figure 18 and secure the end of
(Figure
g030499
19).