First Start-Up - Nokia 7710 User Manual

If the device requests a PIN code, enter the code
(displayed as ****), and tap OK. The PIN code protects
your SIM card against unauthorised use and is usually
supplied with the SIM card. After three consecutive
incorrect PIN code entries, the PIN code is blocked, and
you must unblock it with a PUK code before you can
use the SIM card again. If the codes are not supplied
with the SIM card, contact the operator whose SIM
card is in your media device.
If the device requests a lock code, enter the code
(displayed as *****) and tap OK. The lock code protects
your device against unauthorised use. The factory
setting for the lock code is 12345. Change the code,
and keep the new code secret and in a safe place
separate from your device. The lock code can be from
5 to 10 digits.
Note: Your device has an
internal antenna. As with any other
radio transmitting device, do not
touch the antenna unnecessarily
when the device is switched on.
Contact with the antenna affects
call quality and may cause the
device to operate at a higher power
level than otherwise needed.
Avoiding contact with the antenna
area when operating the device
optimises the antenna performance
and the battery life.
17
The picture shows how you should
hold your device when talking on the
phone. The antenna area is shown in
grey.

First start-up

When you start up your media device for the first time, you
are asked to calibrate the touch screen and define certain
settings.
All the settings can later be modified in the Control Panel
application or in relevant applications.
1
Upon start-up the media device performs a self-test.
After the self-test is complete, you are asked to
calibrate the touch screen. Follow the instructions on
the screen.
2 If the device requests a PIN code, enter the code
(displayed as ****), and tap OK. A welcome screen
appears.
3
To have the time and date set automatically, select the
Auto-update: check box. Tap Finish. If you select the
Auto-update option and the service is available, the
device needs to be restarted. If auto-update is selected
by default and the service is available,
step 6 below) dialog is displayed. Note that some
network operators may not support the
feature.
Settings (see
Auto-update