Mitsubishi Electric MELFA CR800 Series Instruction Manual page 66

4 SAFETY MONITORING FUNCTIONS
Example 2) The following configuration is for outputting DSO1 when SLS1 is enabled and AREA1 disabled.
Caution
Caution
Caution
4-56 Safety Logic Edit
Fig. 4-31: Example of safety output configuration
Output settings for safety monitoring states SS1 and SS2 are supported by RT ToolBox3
Ver. 1.90U or later. To assign SS1 and SS2 to DSO outputs, use RT ToolBox3 Ver. 1.90U
or later.
When SS1 and SS2 are assigned to DSO outputs, pressing [Write] on the Safety Output
screen in RT ToolBox3 Ver. 1.82L or earlier will delete the assignments.
Precautions when using the CR860 controller
The safety output is used to indicate status, not a safety signal. Do not use to control
safety equipment.