Table of Contents
Advertisement
2. The ThinkSystem D3 Chassis can contain up to four 1U nodes or up to two 2U nodes.
Important:
• For proper cooling, each node tray must be installed with either a node or node tray fillers before the
nodes in the chassis are powered on.
D3 Chassis rear view
Figure 7. Chassis rear view
Table 5. Components on the rear view of the D3 Chassis
1
PSU slot 1
(the PSU must be installed with the fan
downward)
2
PSU slot 2
(the PSU must be installed with the fan
upward)
3
PSU slot 3
(the PSU must be installed with the fan
upward)
1
/
2
/
3
PSU slots
Install power supply units to these slots, connect them to power cords. Make sure the power cords are
connected properly.
Important: When installing the power supply units, make sure to follow the instruction on the label in each
slot.
• For slot 1 (
), the PSU must be installed with the fan downward.
1
• For slots 2 and 3 (
and
2
Following are the power supplies supported by the system:
• CRPS 1300-watt Titanium, input power 200-240V
• CRPS 1300-watt Platinum, input power 200-240V
• CRPS 1600-watt Titanium, input power 200-240V
• CRPS 2700-watt Titanium, input power 200-240V
• CRPS 2700-watt Platinum, input power 200-240V
For more information on the power supply LED, see
Chassis midplane
The following illustration shows the location and connectors of the chassis midplane.
), the PSU must be installed with the fan upward.
3
4
Node trays (the nodes must be installed right-side up)
5
Node trays (the nodes must be installed upside down)
"Power supply LED" on page
9.
.
Chapter 2
D3 Chassis components
7
Advertisement
Table of Contents
