Table of Contents
Advertisement
Use safe practices when lifting the chassis.
Procedure
Step 1.
Make preparations for this task.
a.
If shipping brackets are installed on the rear of the rack, remove them. Otherwise, skip this
step.
1.
Remove the screws that secure the rear bracket.
2.
Push the bracket toward the rear of the rack; then, remove the bracket from the rack
and the chassis.
3.
Repeat the above steps to remove the other rear shipping bracket.
Figure 12. Removal of the shipping brackets
b.
If any nodes are installed in the chassis, power off all the nodes and disconnect all external
cables from the nodes; then, remove the nodes from the chassis (see
on page
18).
For the procedures of removing a specific node, see the links below:
• SD530 V3:
• SD550 V3:
Note: If necessary, press the release clip with a flat-head screwdriver to remove an external
network cable from the rear of a 2U node.
20
ThinkSystem D3 Chassis User Guide
https://pubs.lenovo.com/sd530-v3/remove_node_from_chassis
https://pubs.lenovo.com/sd550-v3/remove_node_from_chassis
"Power off the system"
Advertisement
Table of Contents
